Ga direct naar productinformatie
1 van 8

(Eco Kit) Efoil DIY Foil Assist Kit ( 6374 80KV Waterproof Motor +130A Fully Waterproof ESC + MTSKR1905WF Waterproof Remote )

(Eco Kit) Efoil DIY Foil Assist Kit ( 6374 80KV Waterproof Motor +130A Fully Waterproof ESC + MTSKR1905WF Waterproof Remote )

SKU:MTO6374-80-WPC+MTSF130A-WP32+Progcard-FP32+MTSKR1905WF+MICP27F+MTLB8S3P+MTBC3305P

Normale prijs $718.50
Normale prijs Aanbiedingsprijs $718.50
Aanbieding Uitverkocht
Verzendkosten worden berekend bij de checkout.
Motor
Propeller
Battery

Have Doubts? Contact US!!

Because Shipping has regulation on Battery. If you order the kit including 8S3P or 10S3P battery,  after you placing order, we will check and contact you to pay shipping cost for battery separately.

Or you can contact us by messenger or email (support@michobby.com) to check battery shipping cost and shipping time before order.  

24-42V Efoil DIY Foil Assist Kit ( 6374 80KV Waterproof Motor +130A Fully Waterproof ESC + MTSKR1905WF Waterproof Remote )

>>Check Test Data of 6374 80KV Motor with Plastic Propeller (Max 22KG Thrust) and Stainless Steel Propeller (Max 24.6KG Thrust)

1. Fully Waterproof 6374 Motor with New Waterproof Treatment Technology on Rotor and Stator.  

Model No.

MTO6374-80-WPC with 1m long wires (ceramic bearings)

MTO6374-80-WPC2  with 1m long wires (stainless steel bearings)

KV 80, can be customized, contact us
Input Voltage 3-10S Lipo (12.6-42V) Idle Current 0.8A
Max Output Watt 3550W Max Current 65A
Shaft φ8mm, No Output Shaft Hall Sensor Without
Mounting Hole Pattern 28mm, 30mm, 44mm Hole distance Mounting Hole Diameter M4
Customize KV, logo, shaft, mounting hole pattern, color, connector, cable, etc., Bearing Ceramic Bearing or Stainless Steel Bearing
Application Wing foil, wind surf foil, sup foil board, non-electric foil board, kite foil board, underwater thruster, underwater robot, ROV, etc.,

Our advanced waterproof technology:

Rotor magnets with anti-oxidation and anti-rust treatment;
Stator with insulation paint;
Coil Copper wires with transparent insulating varnish;
Wataerproof ceramic bearing or stainless steel bearing.

Some other waterproof motors stator and rotor are full filled with black glue. This kind of black glue may expand when motor heats up, it will expand, then distance between the stator and the rotor will be very small. If rotor and stator scraches each other , it will affect the life of the motor. 
Moreover, if the rotor and stator are full filled with glue, the motor will heat up more easily and the motor power efficiency is poor.

Our waterproof 6374 motor insulating paint is harder than above normal black glue, and even if there is heat, it will not expand to affect the space between the stator and the rotor. It ensures longer motor life!

Difference between ceramic bearing and stainless steel bearing:
Stainless Steel Bearing:
1. Because seawater is corrosive, after some time use may get rust, need to wash with fresh water everytime after use, and keep the motor all dry, so to expand lifespan.
2. Can withstand higher speed.
3. Cost is less than cermic bearing.
Ceramic Bearing:
1. Better anti-rust performance, good for sea water condition
2. It’s brittle, can’t withstand very high speed, easier damage at high speed
3. cost is higher than stainless steel bearing.

2. Maytech New 32Bit 130A ESC Waterproof Speed Controller (Non-VESC)  

Model No.: MTSF130A-WP32
Waterproof Rank: IP68
Cont Current: 130A
Peak Current (at 10S): 150A
Input Voltage: 6-14S Lipo (25-60V) If use with Maytech 6374 80KV Motor, max Voltage is 10S Lipo (max 42V). 
With 5.5V/2A BEC
Size: 96.5*58.5*23.5mm 
Weight: 340g 
Logo: with or Without Logo
Maytech New 32Bit 130A Waterproof ESC Outrunner Motor Speed Controller for Light Weight Efoil
Maytech New 32Bit 130A Waterproof ESC Outrunner Motor Speed Controller for Light Weight Efoil

3. Maytech MTSKR1905WF New Updated version waterproof remote for efoil electric surfboard DIY skateboard longboard (Click for more remote details)

Model No. MTSKR1905WF PCB and Screen Waterproof Rank IP67
Input Voltage Max 75V Signal PWM (PPM)
UART With TX and RX port to connect VESC controllers Double Source Power Supply Accept 5V power by ESC built in BEC or extra 5V power
Control Pump Yes (Relay Switch) on receiver Control Light Yes (Transistor Switch)
Cruise Control Funtion With in SF (Surfboard) Mode Accessories Charging Pad; Receiver; 3pcs Dupont Cables
Display Screen Remote & Battery Voltage; Throttle Percentage; Signal Strength; RPM.
When work with VESC, also display Current; Temp; Volt; Speed&Distance(only for esk8 mode) or RPM (for esurf mode).

4. Plastic or Stainless Steel Propeller 

(1). MICHOBBY MICP27F 3D Printed Plastic (nylon) folding propeller 

Propeller Model: MICP27F (unassembled)
Material: Nylon Powder
Color: Black
Mounting Holes: 8xM4
Max Rotation Diameter: 165mm/6.5'' (Approx.)
Height: 32mm/1.25'' (Approx.)
MICHOBBY MICP27F 3D Printed Plastic (nylon) folding propeller 
(2). MICHOBBY MICP27FM 316L Stainless Steel folding Propeller Metal Propeller
Propeller Model: MICP27FM (unassembled)
Blade Material: 316L Stainless Steel
Propeller Hub Material: Nylon Powder 
Color: Black
Mounting Holes: 8xM4
Max Rotation Diameter: 165mm/6.5'' (Approx.)
Height: 32mm/1.25'' (Approx.)
MICHOBBY MICP27FM 316L Stainless Steel folding Propeller Metal Propeller

5. 8S3P battery or 10S3P battery with charger

(Each batch battery Lenth/Width/Height will have 1-3cm tolerance. Please subject to actual product you receive. Also each batch charger outlook may have some difference. Please note before order). 

  • MTLB8S3P lithium-ion 8S3P Battery Pack

with Molicel 21700 cells
Rated: 29.6V
Full charged: 33.6V
Capacity: 12.6Ah
with BMS
MTBC3305P Battery Charger 
AC: 220V 50Hz
DC: 33.6V 5A

8S3P Battery Pack for Electric SUP Efoil DIY Electric Foil Assist
  • MTLB10S3P lithium-ion 10S3P Battery Pack

with Molicel 21700 cells
Rated: 37V
Full charged: 42V
Capacity: 12.6Ah
with BMS
MTBC4250P Battery Charger 
AC: 220V 50Hz
DC: 42V 5A

10S3P 37V Battery Pack And Charger for Electric SUP Efoil DIY Electric Foil Assist



Alle details bekijken