Efoil DIY Foil Assist Kit ( 6374 150KV Waterproof Motor +160A Fully Waterproof ESC + MTSKR1905WF Waterproof Remote )
Efoil DIY Foil Assist Kit ( 6374 150KV Waterproof Motor +160A Fully Waterproof ESC + MTSKR1905WF Waterproof Remote )
SKU:MTO6374-150-WPC+MTSF160A-WP32+MTUBEC75T5V+Progcard32+MTSKR1905WF+MICP27F
Couldn't load pickup availability
Have Doubts? Contact US!!
Have Doubts? Contact US!!
Efoil DIY Foil Assist Kit ( 6374 150KV Waterproof Motor +160A Fully Waterproof ESC + MTSKR1905WF Waterproof Remote )
Maytech New Motor/ESC/Remote Kit, easily to convert your non-electric foil, wind foil, kite surf, sup board, wing foil, etc to electric.1. Fully Waterproof 6374 Motor with New Waterproof Treatment Technology on Rotor and Stator.
Please note from 21 Setp, 2023, the motor phase wires are updated to 1m long.
Model No. | MTO6374-150-WPC Motor | KV | 150, can be customized, contact us |
Input Voltage | 3-12S Lipo (12.6V-50V) | Idle Current | 0.8A |
Max Output Watt | 3550W | Max Current | 65A |
Shaft | φ8mm, No Output Shaft | Hall Sensor | Without |
Mounting Hole Pattern | 28mm, 30mm, 44mm Hole distance | Mounting Hole Diameter | M4 |
Customize | KV, logo, shaft, mounting hole pattern, color, connector, cable, etc., | Bearing | Ceramic Bearing or Stainless Steel Bearing |
Application | Wing foil, wind surf foil, sup foil board, non-electric foil board, kite foil board, underwater thruster, underwater robot, ROV, etc., |
Our advanced waterproof technology:
Rotor magnets with anti-oxidation and anti-rust treatment;
Stator with insulation paint;
Coil Copper wires with transparent insulating varnish;
Wataerproof ceramic bearing or stainless steel bearing.
Some other waterproof motors stator and rotor are full filled with black glue. This kind of black glue may expand when motor heats up, it will expand, then distance between the stator and the rotor will be very small. If rotor and stator scraches each other , it will affect the life of the motor.
Moreover, if the rotor and stator are full filled with glue, the motor will heat up more easily and the motor power efficiency is poor.
Our waterproof 6374 motor insulating paint is harder than above normal black glue, and even if there is heat, it will not expand to affect the space between the stator and the rotor. It ensures longer motor life!
Difference between ceramic bearing and stainless steel bearing:
Stainless Steel Bearing:
1. Because seawater is corrosive, after some time use may get rust, need to wash with fresh water everytime after use, and keep the motor all dry, so to expand lifespan.
2. Can withstand higher speed.
3. Cost is less than cermic bearing.
Ceramic Bearing:
1. Better anti-rust performance, good for sea water condition
2. It’s brittle, can’t withstand very high speed, easier damage at high speed
3. cost is higher than stainless steel bearing.
2. Maytech New 32Bit 160A ESC Waterproof Speed Controller (Non-VESC) With UBEC and Progcard
Higher power and more easier to be programmed.
Output: 5V/1200mA
Input Volt.: 18-75V

3. Waterproof Remote with receiver
Model No. | MTSKR1905WF | PCB and Screen Waterproof Rank | IP67 |
Input Voltage | Max 75V | Signal | PWM (PPM) |
UART | With TX and RX port to connect VESC controllers | Double Source Power Supply | Accept 5V power by ESC built in BEC or extra 5V power |
Control Pump | Yes (Relay Switch) on receiver | Control Light | Yes (Transistor Switch) |
Cruise Control Funtion | With in Esurf Mode | Accessories | Charging Pad; Receiver; 3pcs Dupont Cables |
Display Screen | Remote & Battery Voltage; Throttle Percentage; Signal Strength; RPM. | ||
When work with VESC, also display Current; Temp; Volt; Speed&Distance(only for esk8 mode) or RPM (for esurf mode). |
4. MICHOBBY MICP27F 3D Printed folding propeller
Propeller Model: MICP27FMaterial: Nylon Powder
Blade: 2 folding Blades
Color: Black
Mounting Holes: 8xM4
Size: 2.7inch from tip to installation
Max Rotation Diameter: 190mm/7.5'' (Approx.)
Height: 32mm/1.25'' (Approx.)


Share












