How to use MTSF160A-WP32 160A Efoil ESC?
2. Continuous current: 160A
3. Burst Current(at 10S):180A
4. Working Voltage: 6-14S Lipocells (Max 58.8V)
5. Net Weight:180g
6. Programmable cable(2-core)：Green-RX，Yellow-TX
7. Signal cable(3-core)：to connect receiver, eg. Maytech MTSKR1905WFreceiver
- Wiring Instruction, signal and programmable cable
To connect MTSKR1905WF receiver：
-
How to do ESC throttle calibration with Remote?
Pleas Refer to Youtube Video:
- Program settings via progcard32
- Connect progcard: It needs to connect ESC to battery to power on progcard. (Battery votage needs to be 6S Lipo and above)
- Program settings (the settings with Dash are Defaults):
This setting is no-use for electric watersports. Please keep it at “OFF”.
2. Brake Type: OFF/ON
This setting is no-use for electric watersports. Please keep it at “OFF”.
3. Motor Timing: Auto/5°/10°/15°/20°/25°/30°
Please keep it at Auto.
4. Motor Rotation: CW/CCW
CW: motor default rotation direction
CCW: Change the direction of motor rotation
5. SR Function: OFF/ON
This setting is no-use for electric watersports. Please keep it at “OFF”.
6. Battery Cells: Auto/6S/8S/10S/12S/14S
Auto: Calculate the number of battery cells based on 3.8V of a single battery cell
Manual setting(6-14S): Manual setting according to different voltage ranges.
7. LVC: OFF/3.0V/3.2V/3.4V/3.6V/NIMH60%
Low voltage protection. For Example: Use a 4s Lipo battery and set it to 3.0V as the low voltage protection value. The low voltage protection value is: 3.0*4= 12.0V.
8. Cutoff Type: Reduce Power/Hard Cutoff
Reduce power: When the battery voltage reaches the preset low voltage protection value, the ESC reduces the output power to 70%;
Hard Cutoff: When the battery voltage reaches the preset low voltage protection value, the ESC immediately shuts down the output power.
9. BEC Voltage: 6V/7.4/8.4V
This setting is no-use for electric watersports. Please keep it at “6.0V”.
10. Acceleratation:Soft/Normal
For Maytech Motors, please select “Soft”.
11. Startup Power: Low/Mid/High
For Maytech Motors, please select “Mid”.
12. Restore Default
To set all setttings to defaults.
-
Program process
1. Turn on the ESC power, pls make sure ESC votlage is over 20V.
2. Connect progcard
3. Press “ITEM” and it will connect progcard to ESC
4. Then you can press “Item” to change switch different setting items. And press△ and ▽ to check each item options. And press”OK” to set the parameters you want ( Option with * is the selected setting).
5. After programming, you need to turn off ESC and disconnect progcard, reconnect ESC power, then adjusted parameters can be effective.
The users manual will be updated along with further product improvements. Pls contact us if any question when you use our products. You can reach us by email to support@michobby.com.