How to use the Two Built-in Switches of MTSKR1905WF and MTSKR20WFV2 Remote?

Posted by Christina Zhang on

The Transistoer switch can be used for LED Light System. 

The Relay switch can be used for LED Light System or Water Pump Motor System. 

Maytech MTSKR1905WF V2 New Waterproof Remote Control for Esk8/Esurf

Maytech MTSKR20WFV2 V2 Remote for Esk8

1. Transistor Switch (MOSFET Switch)

-Connect the SWI switch, your LED light and 3S battery as following shows.

 Fully waterproof remote for electric skateboard longboard robotics walking robotics airplane Esk8 mountainboard all terrain offroad skateboard Esurf Eskate Efoil Foilsurf jetboard jetski hydrofoil

-When (Short press Function button three times) transistor switch is on (display of 【2】in Screen Main interface), transistor switch source will be connected to GND and turn on LED. When it’s off(no display of【2】in Screen Main interface), LED is off.

2. Relay Switch

-Max current of relay switch contacts is 3A. Recommend use this switch for water pump or main lighting system. Recommend to connect as following:

 Fully waterproof remote for electric skateboard longboard robotics walking robotics airplane Esk8 mountainboard all terrain offroad skateboard Esurf Eskate Efoil Foilsurf jetboard jetski hydrofoil

-When relay switch is in original position(no display of【1】in Screen Main interface) , COM(common point) and CLO(normally close) are connected.

-When Short press Function button two times (display of【1】in Screen Main interface) , COM(common point) and OPE(normally open) are connected.


Share this post



← Older Post Newer Post →


Leave a comment

Please note, comments must be approved before they are published.