How to use the built-in switches of MTSKR20WFV2 remote?

Posted by Christina Zhang on

The MTSKR20WFV2 remote has one 30V 3A Relay mechanical switch and one 20V 2A transistor electronics switch for esk8 lights, etc. 

Maytech MTSKR20WFV2 V2 ESK8 Screen Remote for DIY skateboard Compatible with VESC FOCBOX

How to connect each switch? 

Transistor switch (mosfet switch): 

Maytech MTSKR20WFV2 V2 ESK8 Screen Remote for DIY skateboard Compatible with VESC FOCBOX

-When (Short press Function button 4 times) transistor switch is on (display of 【2】in Screen Main interface), transistor switch source will be connected to GND and turn on LED. When it’s off(no display of【2】in Screen Main interface), LED is off.

Relay switch (mosfet switch): 
Maytech MTSKR20WFV2 V2 ESK8 Screen Remote for DIY skateboard Compatible with VESC FOCBOX

-When relay switch is in original position(no display of【1】in Screen Main interface) , COM(common point) and CLO(normally close) are connected.

-When Short press Function button 3 times (display of【1】in Screen Main interface) , COM(common point) and OPE(normally open) are connected.

 


Share this post



← Older Post Newer Post →


Leave a comment

Please note, comments must be approved before they are published.