News — Efoil Electric surfboard

How to check VESC fault code?

Posted by Christina Zhang on

How to check VESC fault code?

After the fault occurs,  1. Please do not power down the VESC. Please connect it to your computer. 2. Startup your computer VESC_TOOL, make the connection of your VESC and VESC_TOOL. 3. And then go to the "TERMINAL" tab. Type: "faults" and send the command. Then VESC will feed back the fault code in VESC_TOOL.

Read more →

Notice and Tips for 300A-400A 85V MTSVESC7.5H Speed Controller

Posted by Christina Zhang on

Notice and Tips for 300A-400A 85V MTSVESC7.5H Speed Controller

Introduction:  MTSVESC7.5H is based on 75V 300A VESC hardware and firmware construction. It is mainly used for controlling brushless motor on mobile devices with 20S and below Lipo battery(max 85V, recommend to use 75V and below). Compared with original 75V 300A VESC, it has better heat dissipation and greater continuous power.  Application Fields:  With the many functions and interfaces of VESC, MTSVESC7.5H can be widely used in high-speed electric scooters, high-speed electric karts, electric motorcycles, electric boats,  electric surfboards, heavy-duty cargo robots, fighting robots, and various special vehicles, etc. Notice before usage:  1. If you will use the VESC for water...

Read more →

Updated 200A ESC Based on VESC75300!! MTSVESC7.12

Posted by Christina Zhang on

Updated 200A ESC Based on VESC75300!! MTSVESC7.12

For more Specifications:  https://michobby.com/collections/vesc-based-controllers/products/maytech-new-200a-mtvesc6-12-based-speed-controller-vedder-benjamin-vesc-for-electric-skateboard-mountainbaord Features: High voltage: If use current mode, without brake, max voltage is 60V; If use current mode with brake or duty cycle mode, max voltage is 12S lipo (Max 50.4V). High current: 200A Compatible with brushed and brushless motors, intrunner and outrunner motors Sensored or Sensorless operation + Hybrid mode Adjustable Forward/Backward/Brake Regenerative Braking Function Configurable RPM, Current, Voltage and Power limits Support PPM, Analog (ADC), UART, Canbus input Support BLDC square wave mode control and FOC sine wave mode Communication ports: USB, CAN, UART Throttle curve and ramping for all input sources Seamless 4-quadrant operation...

Read more →

How to use the Two Built-in Switches of MTSKR1905WF and MTSKR20WFV2 Remote?

Posted by Christina Zhang on

How to use the Two Built-in Switches of MTSKR1905WF and MTSKR20WFV2 Remote?

The Transistoer switch can be used for LED Light System.  The Relay switch can be used for LED Light System or Water Pump Motor System.  Maytech MTSKR1905WF V2 New Waterproof Remote Control for Esk8/Esurf Maytech MTSKR20WFV2 V2 Remote for Esk8 1. Transistor Switch (MOSFET Switch) -Connect the SWI switch, your LED light and 3S battery as following shows.   -When (Short press Function button three times) transistor switch is on (display of 【2】in Screen Main interface), transistor switch source will be connected to GND and turn on LED. When it’s off(no display of【2】in Screen Main interface), LED is off. 2. Relay Switch...

Read more →

Video of Complete Efoil outlook

Posted by Christina Zhang on

Video of Complete Efoil outlook

 

Read more →